Country Living
Country Living, Country Skills
Country People - A Country Living Resource and Community
Message Board
Country Topics
Trading Post
Memory Lane
Country Skills
Country Cooking

The Kitchen

Photo Gallery
Vintage Photos
Special Collections

Country Humor
Country Sounds
Coloring Book
Interactive Story

Farm Tractors
Tractor Parts
Tractor Manuals

Classic Trucks
Antique Tractors
Modern Tractors
Site Map
Links Page
Contact Us

Country Discussion Topics
To add your comments to this topic, click on one of the 'Reply' links below.

OT...Corvette help...
[Return to Topics]

TO35    Posted 04-16-2004 at 03:16:06       [Reply]  [No Email]
Working on the bosses 84 vette, courtesy lights stay on all the time, all I have is a wiring diagram and it shows a courtesy light module, I've had the trim plates, kick panels, and console plates off and cannot find it, can anyone tell me where the courtsey light module is located?

thanks in advance

jay    Posted 11-29-2005 at 15:22:53       [Reply]  [Send Email]
I am having the same problem,I have cleaned all conections.the lights will all go out when i start the car,with car running i f i open each door one at a time the door ajar light will come on,and go off when i shut door.Is there a delay timer in the circut? Thanks Jay

RayNC    Posted 04-16-2004 at 15:46:18       [Reply]  [Send Email]
Try turning the headlight switch clockwise and see if it might just be in the on position. Sometimes we forget to check the obvious first.

Bruce    Posted 04-16-2004 at 05:24:26       [Reply]  [No Email]
Good morning, you might try looking at the wiring close to where it enters the door from the dash. Pinched wire is what it sounds like.

Fern(Mi)    Posted 04-16-2004 at 04:01:17       [Reply]  [No Email]
I haven't had my first cup of coffee yet and you're starting with the hard questions already this morning?
There are just some guy's? lol

With a libray visit, I would be guessing. May ressemble turn signal can only perhaps in black plastic in fuse area. Under dash maybe? Behind or around about master cylinder area?
And, I ain't writing crazy. The way their engeneering vehicals these days I'm getting lost writing this.
Good bye.
I hope my day gets better than this. lol
Did I say Good Morning.

Dennis    Posted 04-16-2004 at 15:36:33       [Reply]  [No Email]
Take some wd40 and spray it into the door lock catches in the door itself and see if that helps.

worked for me

[Return to Topics]

[Home] [Search]

Copyright © 1999-2013
All Rights Reserved
A Country Living Resource and Community