Country Living
Country Living, Country Skills
Country People - A Country Living Resource and Community
Message Board
Country Topics
Trading Post
Memory Lane
Country Skills
Country Cooking

The Kitchen

Photo Gallery
Vintage Photos
Special Collections

Country Humor
Country Sounds
Coloring Book
Interactive Story

Farm Tractors
Tractor Parts
Tractor Manuals

Classic Trucks
Antique Tractors
Modern Tractors
Site Map
Links Page
Contact Us

Country Discussion Topics
To add your comments to this topic, click on one of the 'Reply' links below.

Protecting front fender wiring
[Return to Topics]

JoeK--Willy N    Posted 04-07-2003 at 11:11:36       [Reply]  [No Email]
Yrs back had Willy Plow Pk w/same problem.Using steel brakeline tubing we fabbed tab and brazed to end.Hole in tab goes on lamp mount,tubing followed curve of fender and into engine comp,small conduit clip(s)brazed to tube to secure.After installation "blob" of RTV silicone covers exposed bend of wire and plugs tube to repel debris

Dave Smith    Posted 04-07-2003 at 11:41:41       [Reply]  [Send Email]
I have seen street rod builders use polished stainless steel tubing like that. That is especially nifty when using fiberglass body parts. Then they had the tubing for a ground. Expensive by real nice.

Jimbob    Posted 04-07-2003 at 19:26:21       [Reply]  [No Email]
Quality work, fine business.

Jimbob    Posted 04-07-2003 at 19:26:20       [Reply]  [No Email]
Quality work, fine business.

[Return to Topics]

[Home] [Search]

Copyright © 1999-2013
All Rights Reserved
A Country Living Resource and Community