Country Living
Country Living, Country Skills
Country People - A Country Living Resource and Community
Message Board
Country Topics
Trading Post
Memory Lane
Country Skills
Country Cooking

The Kitchen

Photo Gallery
Vintage Photos
Special Collections

Country Humor
Country Sounds
Coloring Book
Interactive Story

Farm Tractors
Tractor Parts
Tractor Manuals

Classic Trucks
Antique Tractors
Modern Tractors
Site Map
Links Page
Contact Us

Kountry Life How-To

Remove Rusty Nail Stains From Buildings etc.
Tools and Materials Needed;

Paint, Sandpaper, Wire Brush, Paint Remover, Paint Brush, Punch, Undercoat, Caulking Compound

If your bride is like mine, most everthing has to be tidy, tidy, tidy. Fortunately, barn is to far away from house for her most days!! LOL ;)

Anyhow, nails & moisture make an ugly duo. Results are rusty nail stains all along your exterior wood siding and indoors too. Don't just paint over the problem. Fix it so the stains don't magically reappear. Nail heads can rust and create spots on painted surfaces in your home. This problem is caused by using uncoated steel nails where excessive moisture exists under the paint. The uncoated steel nails obviously cannot be removed, but you can correct the moisture problem.

Step 1; Go to the Source;Try to locate the source of excessive moisture. Check for leakage from the eaves, evaporation from nearby plumbing pipes, sweating caused by heat from a bathroom or kitchen. If you can locate the source of moisture, try eliminating the problem by shutting off the condensation that causes the moisture.

Step 2; Remove Rust; Remove any stained paint around all nail heads by sanding the area or using a wire brush. Sand clear down to the nail head, then sand the nail head itself to remove the built-up rust.

Step 3; Punch It!Use a nail punch to countersink all nail heads approx.1/8' below the wood surface.

Step 4; The Cover Up;Apply one even layer of undercoat over the countersunk nail and the area around it. After the area is primed, fill the countersunk hole with a good grade of caulking compound.

Allow the compound to dry, then apply one coat of a good grade of outside house paint. After adequate drying time, apply a second coat. Use these steps to correct the problem.

ShepFL, from FL, entered 2001-07-21

[Home] [Search]

Copyright © 1999-2013
All Rights Reserved
A Country Living Resource and Community