Re: PVC Sausage stuffer

Posted by Tim LeBlanc on October 21, 2004 at 08:34:21 from (65.216.158.130):

In Reply to: PVC Sausage stuffer posted by Bob the butcher on December 11, 2003 at 20:51:28:

I just made a sausage stuffer out of 10 inch stainless pipe. It should hold at least 55 lbs at a time and is air operated. I got the idea from the old E-Z Pack water stuffers. (Go to Zuber Inc. website and look at the 100 lb stuffer for the drawings)Instead of water, I use air to drive the piston from the bottom upward. Cap the bottom of your pipe and on the top lid, place a 1" ball valve to control output. Hardest part is finding a seamless pipe that i.d size is true in diameter. The piston I had made from teflon. You could make a smaller one with CPVC but fittings are expensive when you get into big pipe sizes.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: PVC Sausage stuffer Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.